At Tiger Plumbing, Heating & Air, we know that furnace breakdowns can leave you feeling helpless and without options. Whether your furnace has stopped working altogether or is just running inefficiently, we are here to help. Our professional technicians provide accurate solutions to every heating problem you have.
Reach our team today for dependable furnace repair in Chanhassen, MN.
There are many reasons why a furnace might stop working. From a broken thermostat to faulty wiring, there is no shortage of things that can go wrong with your heating system. If you find yourself in this situation, don’t panic! We will help you figure out what’s wrong and get your furnace up and running again in no time.
This is probably the most common reason for a furnace to stop working. If your thermostat isn’t set to “heat” mode, or if it’s not turned on, the furnace won’t start. Make sure that the batteries are new in your thermostat, and try turning it up a few degrees to see if the furnace kicks on.
However, if your thermostat is working correctly but the furnace isn’t turning on, there might be something wrong with the wiring or the furnace itself. In this case, it’s best to call a professional to take a look at it.
If your furnace runs on gas, it might not be able to start if there’s no fuel. Ensure that the tank is full and try turning up the thermostat a few degrees. If the furnace still doesn’t turn on, there might be something wrong with the ignition system or gas supply.
Of course, having a dusty filter will not do your furnace any good. A clogged filter will prevent the air from flowing through the furnace, which can cause it to overheat or even catch on fire. Change your furnace filter at least once a month to keep it running efficiently.
Not only can it affect the furnace’s performance, but it can also be harmful to your health. A clogged filter can trap allergens and pollutants inside your home, aggravate asthma and other respiratory problems.
When a fuse blows, it can be caused by several things, such as a short circuit, a tripped breaker, or too much current draw. If you think that might be the problem, try flipping the breaker off and then back on. This often resets the breaker and gets it working again.
Remember, be sure to use the same amperage as the blown one. You can find this information on the label or in your owner’s manual.
This is most likely to happen when there’s a sudden cold snap, and the furnace isn’t properly insulated. You can thaw out the coils by turning up the thermostat until the furnace comes on. Once it’s running, turn the temperature back down to a more reasonable level.
As your trusted expert in furnace repair in Chanhassen, MN, we know what to do when your unit isn’t working. We have the experience and knowledge to get it up and running again in no time. If you’re experiencing any of the above problems, don’t hesitate to call us at 952-942-5748! We’ll be happy to help.